Key Programming:
- Blank transponder
- All keys present
- Depending on the model, some remotes are programmed with machines and others are programmed manually.
Manual remote programming procedure:
- Two keys are required.
- Turn the ignition on with one key.
- Exit the vehicle, close the door, insert the key into the door lock, and turn to lock (clockwise).
- The system will give you thirty (30) seconds to complete the programming of the new remote.
- Within 5 seconds, press the “unlock” button once to confirm programming of the remote in the “ON” position. The turn signals will flash once to indicate successful programming. Wait 5 seconds, then press the “unlock” button again to confirm programming and turn off the ignition.
If programming is unsuccessful, erasing is necessary.
ERASING
- Turn on the ignition.
- Manually lock the driver’s door with the key.
- Press the unlock button 5 times at 1-second intervals.
- The turn signals will flash once to indicate the signal has been received. Wait 6 seconds
- Press the unlock button once to confirm deletion.
- Remove contact
- Reprogram them.
Transponder:
- ZedfullI: D48
- Tango: ID48
- Keydi: ID48
- Handy: ID48
- VVDI: ID48
- Clonable: YES
